Step one: Fold paper in half long-wise and fold
in the corners to the crease. This is the easy bit..
Step
two: Mark off (or estimate if you're good!), three equal
divisons on the model and fold along the outer-most division..
Step three: Fold the tip of your Spoiler model
down onto the first (inside) fold and just make a crease..After
that fold it back up.
Step
Four: Flip your Spoiler over and fold back over the crease
you made in step three. You've just made a weighted nose.
Step Five: With the tip sill folder over, fold
the outer sides into the center cease, then return .
Step Six: Lets' do a mountain fold now, folding
the outer sides back.
Step Seven: We need to drop down the wings next
and we'll keep them in close to the fuselage for the time being.
This is a good time to put a quick staple through the fuselage
to keep things tight and tidy...
Step Eight: With the wings still flat, fold the
corners along a line that's parallel to the leading edge of the
wing..
Step Nine: NOW, we'll bring those wings up into
flying position and adjust those little spoiler tabs that will
make your model the WORSE flying model you'll ever see.. :-)
Launch your little spoiler with a gentle level throw.. The model
will stop at the end of it's labored flight adn float gently
to earth... Scare the heck out of the cat...
Step
two: Mark off (or estimate if you're good!), three equal
divisons on the model and fold along the outer-most division..
Step
Four: Flip your Spoiler over and fold back over the crease
you made in step three. You've just made a weighted nose.
