Fiddlers Green

'ere's F8F-2D drone controller repaint that I did;

had to do a minor bug fix with the design, 'cause the rear fuselage section wouldn't fit without a largish gap, turned out that the back of the center fuselage section was to small. So hopefully that's fixed, leastways 'tis in micro scale!
There is one problem tho, the tab that connects the horizontal stabilizer to the fuselage overlaps some of the markings, so should I trim down the tabs (easy) or put the overlapped part of the markings on the tab? (hard)

_________________
Currently working on: Brewster F2A Buffalo, NA BT-9
Recently completed: P-38 Lightning in 1:172

Looks very nice WII. Besides the coloring, I like the highlighting you rendered on the wingtops and fuselage. Regarding the tabs - simple is best.

_________________
Regards,
Don

Currently working on: 1/72 FG Wildcat
Recently completed: 1/72 FG Crosby CR-4

thanks Don! I did end up chopping the tabs dow a little bit.

the final bata:

_________________
Currently working on: Brewster F2A Buffalo, NA BT-9
Recently completed: P-38 Lightning in 1:172

just checked, & it's in the F8F folder! this is the second repaint that I've done that has made it to its respective folder. I think the most of the others were to old or somethin'. The P-38 was for sure, The Wildcat probably would 'ave if I'd a did a lot o' design fixin'.

_________________
Currently working on: Brewster F2A Buffalo, NA BT-9
Recently completed: P-38 Lightning in 1:172