Fiddlers Green

F8F-2D drone controller
Page 1 of 1

Author:  WII [ Fri Jun 12, 2009 9:34 am ]
Post subject:  F8F-2D drone controller

'ere's F8F-2D drone controller repaint that I did;
had to do a minor bug fix with the design, 'cause the rear fuselage section wouldn't fit without a largish gap, turned out that the back of the center fuselage section was to small. So hopefully that's fixed, leastways 'tis in micro scale!
There is one problem tho, the tab that connects the horizontal stabilizer to the fuselage overlaps some of the markings, so should I trim down the tabs (easy) or put the overlapped part of the markings on the tab? (hard)

Author:  jusfiddlin [ Fri Jun 12, 2009 1:09 pm ]
Post subject: 

Looks very nice WII. Besides the coloring, I like the highlighting you rendered on the wingtops and fuselage. Regarding the tabs - simple is best.

Author:  WII [ Tue Jun 23, 2009 2:06 pm ]
Post subject: 

thanks Don! I did end up chopping the tabs dow a little bit.

the final bata:

Author:  WII [ Tue Jun 23, 2009 2:22 pm ]
Post subject: 

just checked, & it's in the F8F folder! this is the second repaint that I've done that has made it to its respective folder. I think the most of the others were to old or somethin'. The P-38 was for sure, The Wildcat probably would 'ave if I'd a did a lot o' design fixin'.

Page 1 of 1 All times are UTC - 7 hours
Powered by phpBB® Forum Software © phpBB Group