Fiddlers Green
http://www.fiddlersgreen.net/forum/

Printing on the Back Side of Walls
http://www.fiddlersgreen.net/forum/viewtopic.php?f=9&t=622
Page 1 of 1

Author:  bennetim [ Sun Feb 12, 2006 8:09 pm ]
Post subject:  Printing on the Back Side of Walls

I found that by going into my printer properties I could select "mirror image" as a print option. When printing a free standing wall or part of a building in which the back side or inside would show, I could print it once and then turn the paper over, select "print mirror image", and print again. This gives me stone or wood on the back sides or insides of walls for those areas that are visible on the finished model. It works great for models like the the Norman Castle where you can see the back sides of the free standing walls. I have Windows XP and an HP psc 950 printer. I bet it is available on other set ups as well.

Page 1 of 1 All times are UTC - 7 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/